Before starting today's article summary, let's ask our friends a question. Have you ever had a sudden shutdown when using the reprint machine? Then how did this phenomenon happen? Is there a solution? So let's make a detailed summary and share with our friends today. Interested friends can read on. Of course, if we have any questions in the process of summarizing and sharing, We can communicate and discuss at any time.

遇到停机的转台就要确定一下，发动机供油管中是不是进入了空气中，造成了供油中断。油路中的密封性不够造成的，在这里呢小编给朋友们分享一个小技巧。

In case of shutdown of the turntable, it is necessary to first determine whether the oil supply pipe of the engine has entered the air, resulting in the interruption of oil supply. It's caused by insufficient sealing in the oil circuit. Here, I'd like to share a little skill with my friends.

可以用在停机后对燃油系统排空气体的方法来判断。假如根据用手油泵泵油，在排空气体螺钉处释放很多泡沫状油气泡，则为油中油气所致停机。应认真仔细低压油路的密闭性。喷油泵凸轮轴折断或滚键，连接板断裂，应检修喷油泵。

It can be judged by emptying the fuel system after shutdown. If the oil is pumped by hand oil pump, a lot of foam oil bubbles will be released at the vent gas screw, which will cause the shutdown of the oil and gas in the oil. Carefully check the tightness of low-pressure oil circuit. If the camshaft of the fuel injection pump is broken or the rolling key and the connecting plate are broken, the fuel injection pump should be repaired.

装载机的零件在疲劳破坏过程中，其裂纹的程度是逐渐扩展的，同时其程度又是可以探测的。当探测到装载机某些部件的裂纹扩展的程度已接近允许的临界值时，便认为是存在潜在故障，也需要按实际故障一样来处理。

In the process of fatigue failure of loader parts, the degree of crack is gradually expanding, and its degree can be detected at the same time. When it is detected that the crack growth degree of some parts of the loader is close to the allowable critical value, it is considered that there is a potential fault, which also needs to be handled according to the actual fault.

及时的探明了装载机的潜在故障，就有可能在装载机达到功能故障之前进行排除，这有利于保持装载机完好状态，避免由于发生功能故障而可能带来的不利后果，这在装载机的使用维修实际中具有重要意义。

If the potential faults of the loader are found out in time, it is possible to eliminate them before the loader reaches the functional fault, which is conducive to keeping the loader in good condition and avoiding the possible adverse consequences due to the functional fault, which is of great significance in the use and maintenance of the loader.