When operating the underground loader, there are several misunderstandings that need your attention. In particular, novice drivers are more likely to "step on thunder", have less operation experience and are eager for success, so it is easy to break into some operation misunderstandings. Xiaobian has sorted out four common misunderstandings for you, hoping to let you avoid them in time!

1、猛轰油门，井下装载机不管是在行走中还是在铲装作业过程，都不要用力踩踏油门踏板，始终保持油门控制的轻稳平缓性。充分减少和降低操作中的人为故障。

1. Slam the accelerator. Do not step on the accelerator pedal when the underground loader is walking or shoveling, and always keep the light, stable and gentle throttle control. Fully reduce and reduce man-made faults in operation.

2、轮胎打滑，井下装载机在进行作业的时候，遇有阻力而猛加油门往往会出现轮胎打滑现象。产生这种现象一般不是装载机的问题，通常是由于司机的错误操作所导致的。这样既增加了燃料的消耗，又造成了轮胎的损伤，而且会造成不必要的麻烦。因此，对井下装载机驾驶员来说这种现象应该严加禁止。

2. The tire skids. When the underground loader is working, it often skids in case of resistance. This phenomenon is generally not the problem of the loader, but is usually caused by the wrong operation of the driver. This will not only increase fuel consumption, but also cause tire damage, but also cause unnecessary trouble. Therefore, this phenomenon should be strictly prohibited for underground loader drivers.

3、后轮翘起，由于井下装载机掘起力度大，如果操作不得当就很容易出现后两轮的翘起，甚离地面很高的情况。周而复始的这些翘起动作的落地惯性，会造成铲斗的刃板断裂、铲斗变形。因此，在铲挖操作过程中，应该严格禁止后轮的翘起。

3. The rear wheels are tilted. Due to the strong digging force of the underground loader, if the operation is not proper, it is easy to tilt the last two wheels, even high from the ground. The repeated landing inertia of these tilting actions will cause the blade of the bucket to break and the bucket to deform. Therefore, during the digging operation, the warping of the rear wheel should be strictly prohibited.

4、严禁撞击料堆，井下装载机在工作时，普通物料可以用二档铲挖工作。而严禁以二档以上的档位向料堆作惯性冲击！正确地方法应该是铲斗在接近料堆时适时地把档位转换为一档来完成一个铲料的过程。

4. It is strictly prohibited to hit the material pile. When the underground loader is working, ordinary materials can be dug with the second gear shovel. It is strictly prohibited to make inertial impact on the material pile at the gear above the second gear! The correct method should be to timely change the gear to the first gear when the bucket is close to the pile to complete a shovel process.

以上就是今天小编给大家提供的精彩内容，更多的精彩内容请点击进入我们的网站：矿井装载机http://www.kuangjingjixie.com

Please click on the above website to provide you with more wonderful content today http://www.kuangjingjixie.com