When the parts of the loader are in bad condition, the water temperature will be too high, the action will be slow, boiling and so on. Now let's analyze and solve the problem of high water temperature of the loader.

装载机水温高的原因：

Reasons for high water temperature of loader:

1、装载机配件节温器失灵造成水不能经水箱散热，防冻液比例过低；水中有杂物导致水管堵塞，水箱有水垢，散热不好加上大负荷工作时间过长。

1. The failure of thermostat of loader accessories results in the water can not be dissipated through the water tank, and the proportion of antifreeze is too low; Debris in the water leads to water pipe blockage, water tank has scale, poor heat dissipation and long working time under heavy load.

2、装载机配件风扇皮带松紧度欠佳，风扇损坏，水泵水循环不好，导致装载机水温高故障。

2. The belt tightness of the loader accessories fan is not good, the fan is damaged, and the water circulation of the water pump is not good, which leads to the high water temperature fault of the loader.

3、装载机节温器故障，水箱脏，导致装载机水温过高，点火时间不对，水箱水循环不好散热器内堵了。

3. The thermostat of the loader fails and the water tank is dirty, which leads to the high water temperature of the loader, the wrong ignition time, the poor water circulation of the water tank and the blockage of the radiator.

4、装载机发动机故障，也有可能导致装载机水温高故障现象的发生。

4. The engine failure of the loader may also lead to the high water temperature of the loader.

装载机水温高维修建议：

Maintenance suggestions for high water temperature of loader:

1、出现装载机水温高、动作慢现象后，装载机老师可以拆掉装载机配件节温器，检查装载机发动机内防冻液的汇兑比例，然后检查水箱是否有污垢，水箱内水循环是否正常，确认水泵有没有故障，检查装载机的风扇皮带，发动机有没有故障。

1. When the water temperature of the loader is high and the action is slow, the loader teacher can first remove the thermostat of the loader accessories, check the proportion of antifreeze in the engine of the loader, then check whether there is dirt in the water tank, whether the water circulation in the water tank is normal, confirm whether the water pump is faulty, and check whether the fan belt and engine of the loader are faulty.

2、装载机水温高沸腾，可以先清洗散热器，然后换一个新的风扇，再调效液压泵流量，减轻发动机的负荷，再看装载机水温高沸腾故障是否排除。另外，出现了装载机水温高沸腾现象，需要排查装载机的水箱，水循环，风扇皮带松紧程度，点火时间，节温器等情况是否正常。

2. If the water temperature of the loader is high boiling, you can clean the radiator first, then replace it with a new fan, adjust the flow rate of the hydraulic pump, reduce the load of the engine, and then see if the high boiling fault of the loader water temperature is eliminated. In addition, there is a phenomenon of high boiling water temperature of the loader. It is necessary to check whether the water tank, water circulation, tightness of fan belt, ignition time, thermostat and other conditions of the loader are normal.

3、装载机出现水温高等问题，主要原因之一是装载机配件出现问题，所以在日常操作和护理中，要做好装载机配件的护理和检查工作。

3. One of the main reasons for the high water temperature of the loader is the problem of the loader accessories, so in the daily operation and nursing, we should do a good job in the nursing and inspection of the loader accessories.