The mining loader is mainly used for the collection, transportation, construction and loading of crushed stone and soil materials in various hydropower, mining and tunnel projects such as phosphate, copper, iron ore, gold, silver, lead-zinc, coal mine roadway and so on. The correct operation of the mine loader can prolong its service life. However, in daily use, it is difficult to avoid the loader from failure. What is more common is that the loader suddenly stalls. What should be done?

1、矿用装载机在作业、行驶中发动机突然熄火，驾驶员可以快速启动发动机，如果启动发动机失败，可利用车辆存留的气源踩刹车进行紧急制动，选择合适的地带进行停车检查处理。

1. If the engine of the mine loader suddenly stalls during operation and driving, the driver can quickly start the engine. If the engine fails to start, he can use the air source left by the vehicle to step on the brake for emergency braking, and select an appropriate area for parking inspection and treatment.

2、如果发动机熄火后，制动气源不够的话，可利用手制动和铲斗摩擦地面方式来实现停车。

2. If the brake air source is insufficient after the engine is shut down, the parking can be realized by means of hand brake and bucket rubbing the ground.

3、如果在坡道上进行车辆检查修理的时候，需要采取止轮措施。

3. If the vehicle is inspected and repaired on the ramp, wheel stopping measures need to be taken.

4、再次重新打火试试能否正常启动，有时可能是变速箱与发动机动力输出轴还处于齿轮啮合状态下刹车，导致变速箱传输了巨大的反向阻力，而迫使发动机出现保护性熄火。

4. Start again and try to start normally. Sometimes it may be that the transmission and the engine power take-off shaft are still in gear meshing, resulting in huge reverse resistance transmitted by the transmission and forcing the engine to stop protectively.

5、装载机在全部档位的情况下都是熄火，可以尝试检查下变速箱，如果其中油里含有大量铝沫渣子等杂质，则说明该装载机变矩器坏了。

5. The loader stalls in all gears. You can try to check the gearbox. If the oil contains a large amount of aluminum foam residue and other impurities, the torque converter of the loader is broken.

6、熄火后，直接检查下高压泵是否老化，是否需要更换。

6. After flameout, directly check whether the lower high-pressure pump is aging and needs to be replaced.

遇到矿用装载机突然熄火的话，一定要采取正确的方法出处理，只有这样才能很好地保证矿用装载机的正常运行。

In case of sudden flameout of the mining loader, we must take the correct method to deal with it. Only in this way can we well ensure the normal operation of the mining loader.